Home Products Support Service Forum Order Contact Us CoreWind Technology
The User Manul for Mini210/Tiny210SDK1/SDK2 Board
1. Quickly Start
  1.1  Getting Start for Mini210s
  1.2  Getting Start for Tiny210
  1.3  System Update for Mini210s
  1.4  System Update for Tiny210
2. System Test method
  2.1  Touchsreen
  2.2  rotating screen
  2.3  Play MP3
  2.4  Recording
  2.5  WiFi Internet
  2.6  CMOS camera
  2.7  HDMI output
  2.8  GPS Test
  2.9  Ethenet Setting
  2.10  3G Networking
  2.11  3G SMS
  2.12  Dial-up via 3G
  2.13  USB Bluetooth
  2.14  USB Disk, SD card
  2.15  Backlight Control
  2.16  Serial Port
  2.17  LED Testing
  2.18  PWM Buzzer
  2.19  ADC Testing
  2.20  I2C-EEPROM
5. Board Introduce
  5.1  Different in Tiny210/Tiny210V2
Getting Start for Tiny210
Board Support: Tiny210SDK1, TinySDK2

1 Unboxing Tiny210SDK1/Tiny210SDK2

So you just received your Tiny210SDK1/Tiny210SDK2 board and you may be wondering where to start... This is the right place to get going.

2 Required Accessories

One Tiny210SDK1/Tiny210SDK2 Board
One LCD Module(5.0"LCD or 7"LCD)
One Serial cable
One net cable
One Mini-USB cable
One 5V@2A Power adapter

3 Connection Guide

1.Set the Boot mode switch(A) for Nand Flash boot mode.
2. Insert the power adapter to the Power interface(D), Don't power on the board.
3. Using a serial cable, connect the Debug serial port(C) of the Tiny210SDK1/Tiny210SDK2 board to the Serial Port on your PC.
4. insert the LCD cable to the LCD interface(E).
5. Power on the board(B), you can enter the Android system default.

4 Hyperterminal setting on PC

Open the DNW software, and configure it as follow:
1) Find DNW software under directory CD:\Tools\DNW.exe. Double-click to open it:
2) Click “Configuration -> Options”, it will open the “UART/USB Options” dialog.
choose '115200' in 'Baud Rate'
choose 'COM1' in 'COM Port '(the COM1 means the serial number in PC  )
3) click 'OK' to finish the DNW configuration:
4) Click 'Serial Port->connect' to enable the DNW serial link.
Power on the board, then you can enter the Android system by the Hyperterminal on PC default.
If you want to use the other system, you can burn the system to board as the follow chapter.

5 Key board on the Tiny210SDK1/Tiny210SDK2 

Tiny210 have 8 keys, the position is as follow:
The function is as follow: 
K1->Home            K5-> V-
K2->Menu            K6-> V+
K3->Connect         K7-> BACK
K4->Disconnect    K8-> Power
  Tel: +86-755-29638421  |    Sales Email: market@armdevs.com |  Support Email: support@armdevs.com | Gtalk: armdevs@gmail.com  
www.armdevs.com | Copyright @2012 - CoreWind Technology Co.,Limited