Home Products Support Service Forum Order Contact Us CoreWind Technology
The User Manul for Mini210/Tiny210SDK1/SDK2 Board
1. Quickly Start
  1.1  Getting Start for Mini210s
  1.2  Getting Start for Tiny210
  1.3  System Update for Mini210s
  1.4  System Update for Tiny210
2. System Test method
  2.1  Touchsreen
  2.2  rotating screen
  2.3  Play MP3
  2.4  Recording
  2.5  WiFi Internet
  2.6  CMOS camera
  2.7  HDMI output
  2.8  GPS Test
  2.9  Ethenet Setting
  2.10  3G Networking
  2.11  3G SMS
  2.12  Dial-up via 3G
  2.13  USB Bluetooth
  2.14  USB Disk, SD card
  2.15  Backlight Control
  2.16  Serial Port
  2.17  LED Testing
  2.18  PWM Buzzer
  2.19  ADC Testing
  2.20  I2C-EEPROM
5. Board Introduce
  5.1  Different in Tiny210/Tiny210V2
Board Support: Tiny210,Tiny210V2,Mini210S

Android System

Set the 3G network as the "3G Networking", then you can send the SMS.

Linux System

Set the 3G network as the "3G Networking", then you can send the SMS.
Please go to “FriendlyARM” and click on “GPRS SMS”
If the connection is a success, the status will show “Ready”. Occasionally it shows “Device Initing…” 
and this suggests that the previous shutdown was an abnormal operation or the previous Modem connection wasn’t disconnected or your connection isn’t good. We recommend users to use a USB to Serial convertor to connect a Modem.
(1) Single sending messages
Please input your target cell phone number in the edit box on the right side of “To:”, type your message in the edit box below “Input” and click on “Send”.
If the sending is a success and the telecommunication service provider sends back an acknowledgement you will see the “Status” shows “Get SMS OK”.
You can send messages to your own cell phone for testing too
The format of the cell phone number varies in different countries:
In mainland China it is “+8613800138000” or “13800138000”.
On Abroad you need to add a country code prior to the number e.g. “+4423645789”. The
number after “+” composes of the country code first and the cell phone number then.
Note: there is no Chinese input utility in the system therefore if you want to send message in Chinese you have to copy and paste it from elsewhere.

WinCE System

Add it later...
  Tel: +86-755-29638421  |    Sales Email: market@armdevs.com |  Support Email: support@armdevs.com | Gtalk: armdevs@gmail.com  
www.armdevs.com | Copyright @2012 - CoreWind Technology Co.,Limited